Westcan Ford Transit Shelving & Upfit Parts
Ford Transit shelving from Westcan is cut for the Transit rather than adapted to it, which is why every part in this collection publishes fitment down to roof height and wheelbase. Coverage runs across the Transit 150, 250, 350 and 350 HD in low, medium and high roof, on 130 inch, 148 inch and 148 inch extended wheelbases, and it spans the whole upfit: two to five shelf units and fold-up shelving, fixed, contoured and sliding-door safety partitions, phenolic floor liners with wall, ceiling and door kits, heavy duty drawer units, and trade packages for electricians, plumbers, HVAC, locksmiths, couriers and general contractors. Westcan builds all of it in aluminum in British Columbia. Part of the Westcan catalogue.
Aluminum Transit shelving, partitions and liners, matched to roof height and wheelbase
The Transit is the most heavily covered van in Westcan's catalogue because Ford builds it in three roof heights, three wheelbases and single or dual sliding doors. Westcan CNC-cuts each part in British Columbia for one combination, so the 2014 and newer Transit 250 high roof partition is a different part number from the low roof version, and the compatibility table on each product page says which you need. Every listing carries Westcan's estimated install time, and brackets, fasteners and instructions ship in the box.
Shop Transit upfit parts by type
Shelving and fold-up shelving
Vehicle-specific two to five shelf units, fold-up units such as the two-shelf 32 inch long by 18 inch deep by 54 inch high unit for the low roof, and 84 inch fold-up upper mount kits for the medium and high roof walls. End panel kits at 17 inches deep by 72 inches high come singly or as Bulk Buy packs. Each shelf carries 55 lb per linear foot.
Safety partitions
Fixed partitions in solid, perforated and windowed panels for every roof height, contoured partitions for the low and medium roof, windowed and perforated sliding door partitions for the 250, 350 and 350 HD high roof, and driver-side-only Gen 2 partitions where you need walk-through access on the passenger side.
Floor, wall, ceiling and door liners
Phenolic floor liners with a hexagon anti-slip surface are cut per wheelbase. Wall and ceiling liner kits are listed by wheelbase and roof height, and door liner kits differ between single and dual sliding door vans. Liners go in first and give everything after them a mounting surface.
Trade packages and drawer packages
Basic Starter, Starter Plus, Electrician, Plumber, HVAC, General Contractor, General Service, Locksmith and Courier packages, each specified for one Transit configuration, such as the Courier package for the 130 inch wheelbase low roof. A package bundles shelving, partition and accessories under one part number. Heavy duty drawer packages are listed the same way, for example the 148 inch wheelbase medium roof.
Shop by vehicle
- Transit 250 and 350: the widest coverage, in low, medium and high roof on all three wheelbases.
- Transit 150: low and medium roof partitions, liners and packages.
- Transit 350 HD: high roof partitions and shelving shared with the 250 and 350.
- Other Ford work vehicles are in Ford parts and accessories. Westcan builds the same range for the Ram ProMaster and the Mercedes-Benz Sprinter.
Why Westcan for the Transit
- Cut for the Transit. Shelving follows the wall contour and partitions match the roof height, so there is no trimming on the shop floor.
- Every part lists an install time. Each listing here carries Westcan's estimate, from a door liner kit to a full trade package.
- Aluminum construction. Lighter than steel, so more of the payload stays available, and a chipped edge does not rust.
- Hardware included. Brackets, fasteners and instructions ship with every part.
Choosing the right Transit parts
Confirm three things against the compatibility table on the product page. Roof height, because a high roof shelving unit will not go into a low roof van. Wheelbase, because it sets the liner lengths and the number of shelf bays. Door configuration, because sliding door liners and partitions differ between single and dual sliding door vans. For a full upfit, fit liners first, then the partition, then shelving and drawers, then accessories. Depending on the trim level of your van, some modification may be required. If you are not sure what fits, contact us with your year, make, model and configuration.
Common questions
Which Ford Transit roof heights does Westcan shelving fit?
Low, medium and high roof. Each part names the roof heights it fits, with the wheelbases and model years, in the fitment table on the product page.
Does Westcan shelving fit the Ford E-Transit?
The E-Transit uses the Transit cargo body, but the fitment tables here name the Transit 150, 250, 350 and 350 HD. Send us your E-Transit roof and wheelbase and we will confirm which parts apply before you order.
What is in a Transit trade package?
The shelving, partition and accessories a trade typically needs, specified for one Transit roof and wheelbase. Basic Starter and Starter Plus are the smallest; Electrician, Plumber, HVAC and General Contractor packages add more storage.
How long does a Transit upfit take to install?
Each product page publishes Westcan's estimated install time. A liner kit is a short job; a full trade package with partition, shelving and liners is most of a day.